Essilor ALM 700 User Manual

13
4.2 Preparation for Measurement
4.2.1 Device Setting
This device is ready for use with the standard mode but the setting can be changed easily
as needed.
Switch to the Setup (setup of device) screen by touching
at the bottom
of screen.
4.2.2 Setup (Device Setting) Screen
【1/4 screen】
Item Description of Function
Cyl Selects sign for Cyl：- / ＋ / ±
Selects step to display measurement value
Step
0.25 / 0.12 / 0.01
Sets auto detection of progressive lens Auto
Prog.
On / Off
Selects lens to be measured
Lens
Normal： Framed lens
H CL： Hard contact lens
S CL： Soft contact lens
Sets auto memory at the time of “Marking OK” Auto
Memory
On / Off
Selects auto/ manual memory of far and near
points
ADD
Measure
F/N.AT： Stores both near and far points
automatically
N.AT： Stores only near point automatically
Manual： Stores data manually
Selects if performing PD measurement or not
PD
Measure
On： Perform / Off： Not perform
Change of switch function
The functions of each switch are changed on the menu screen.
The icons are displayed on the screen. Touch the icon in accordance with the display.
：Moves the cursor downward at each setting item
：Moves the cursor upward at each setting item
：Goes to a further page of Setup. ( → → → )
：Selects the item of each setting item. The selection cursor moves vertically.
：Switches back to the measurement screen.
NOTE

Essilor ALM 700 Specifications

General

Brand	Essilor
Model	ALM 700
Category	Measuring Instruments
Language	English