EVS XT2+ User Manual

Issue
10.05.A
XT2+ Series DISK RECORDER – Version 10.05 - Hardware Technical Reference
EVS Broadcast Equipment SA – July 2011
68
Note
When booting the HCTX board, LEDs 1 to 8 will light according to the
following sequence :
Hardware reset

all LEDs on (1 : red ; 2
to 7 : green)
Setup of CPU basic
registers

LED 2 on (green)
Check of CPU/PC
DPRAM

if error: LED 1 on (red)
+ LED 8 on (green)

if check is successful:
LED 3 on (green)
Polling for PC
commands

LED 4 on (green)
Switching to enhanced
mode

LED 5 on (green)
Executing PC
commands until
execution requests end
LED 6 on (green)
Jump to SDRAM and execute microcode
CONNECTORS
On the XNet2 module (SDTI) :
J3: Not used.
J4: Not used.
J5: OUT connector for XNet2 (SDTI network 1485Mbps without relay).
J6: IN connector for XNet2 (SDTI network 1485Mbps without relay).
Note
J5 must be used with J6. Never use J3 with J5 or J4 with J6.
GIGABIT CONNECTORS
The two Gigabit connectors of the card are connected to the two Gigabit ports of
the backplane.
The Gigabit connectors must be on a network that supports Jumbo Frames of (at
least) 9014 bytes Ethernet frames. One of the tested switch belongs to the Cisco

EVS XT2+ Specifications

General

Brand	EVS
Model	XT2+
Category	Server
Language	English