FlexRadio Systems FLEX-5000 Series User Manual

H A R D W A R E I N S T A L L A T I O N C H A P T E R 1
Front Panel
(1) LED Push Button Power Switch
The FLEX-5000 uses a delayed start push button to power up the radio.
 To turn on the radio, push the button in fully and release. After a few seconds you will hear the
power relay click and see the blue LED illuminate to indicate that the radio is powered up.
 To turn off the radio, again push the button fully and release.
 For the FLEX-5000C the power switch turns on both the radio and the computer, but only
turns off the radio. To shut down the computer, click Start (bottom left of screen) and select
Turn Off Computer.
Note 1: Make sure the FLEX-5000 is turned on and then wait 10-15 seconds
before starting PowerSDR. Otherwise, PowerSDR will indicate a
communication error and offer the option to run in Demo mode. Click
No to close PowerSDR, turn on the FLEX-5000 and restart PowerSDR.
4  2003-2008 FlexRadio Systems
Figure 1: FLEX-5000A (top) and FLEX-5000C (bottom) Front Panel

FlexRadio Systems FLEX-5000 Series Specifications

General

Brand	FlexRadio Systems
Model	FLEX-5000 Series
Category	Transceiver
Language	English