P O W E R S D R I N S T A L L A T I O N & S E T U P C H A P T E R 2
WARNING! Make sure you have an antenna connected to the Transmit
antenna port you selected. Failing to do so may damage your
radio and void your warranty.
WARNING! Do not switch the transmit antenna while transmitting (hot
switching). You could damage your radio and void your
warranty.
Switch Relay with TR: Select the keying line(s) you use, if any, to key your amplifier(s) or
other external equipment. If you want to sequence the switching, set the appropriate Delay
times for each keying line.
Close the Antenna Form when you are done.
Audio Mixer
The FLEX-5000 input and output audio channels are managed with an audio mixer, much the same as
for your Windows sound card(s). To configure the audio mixer, click on Mixer on the Front Console
menu (Figure 31).
Select the desired Input and Output channels. Only one Input channel can be selected, but multiple
Output channels can be selected. Mic is the front panel microphone connector, whereas all other
channels refer to the various audio inputs and outputs on the back panel. For more detailed information
see page 148).
Note: The Internal Speaker output is unavailable for the FLEX-5000A, which
has no internal speaker.
46 2003-2008 FlexRadio Systems
Figure 31: Audio Mixer
To Next Page
Loading...
Need help?
General
