FlexRadio Systems FLEX-5000 Series User Manual

U P D A T I N G T H E F L E X - 5 0 0 0 F I R M W A R E A P P E N D I X B
Update the Firmware
To update the firmware, power-up the FLEX-5000, make sure it is communicating with your computer.
You can verify this by successfully opening the FLEX-5000 Driver Control Panel. Close this Control Panel
if you opened it.
Next, locate the batch file labeled Burn.bat in the firmware folder (the same folder containing the
ReadMe file) and double-click on it to open the window shown in Figure 184 below.
Press any key to continue and you will subsequently receive the message Uploading Binary, followed
by Deleting Flash Image and then Programming Flash Image, each preceded by a progress
counter. When the upgrade is completed successfully you will hear the relays click and see the screen
shown in Figure 185 below.
[The rest of this page has been left blank intentionally]
208  2003-2008 FlexRadio Systems
Figure 184: Burn.bat Initial Screen

FlexRadio Systems FLEX-5000 Series Specifications

General

Brand	FlexRadio Systems
Model	FLEX-5000 Series
Category	Transceiver
Language	English