Fortinet FortiGate FortiGate-3000 Install Guide

Factory defaults
FortiGate-3000 and FortiGate-3600 FortiOS 3.0MR4 Install Guide
01-30004-0270-20070215 27
Factory default Transparent mode network configuration
In Transparent mode, the FortiGate unit has the default network configuration
listed in Table 7 on page 27.
Factory default firewall configuration
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can be accepted by or pass through the
FortiGate unit. To allow traffic through the FortiGate unit, you can add firewall
policies. See the FortiGate Administration Guide for information on adding firewall
policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
Table 8: Factory default firewall configuration
The factory default firewall configuration is the same in NAT/Route mode and
Transparent mode.
Table 7: Factory default Transparent mode network configuration
Administrator
account
User name: admin
Password: (none)
Management IP
IP: 0.0.0.0
Netmask: 0.0.0.0
DNS
Primary DNS server: 65.39.139.53
Secondary DNS server: 65.39.139.63
Internal HTTPS, Ping
External Ping
Port 1 Ping
Administrative access Port 2 Ping
Port 3 Ping
Port 4 Ping
Port 4/HA Ping
Port 5/HA Ping
Configuration setting Name Description
Firewall address All Firewall address matches the source or
destination address of any packet.
Pre-defined service More than 50
predefined services
Select from any of the 50 pre-defined
services to control traffic through the
FortiGate unit that uses that service.
Recurring schedule Always The recurring schedule is valid at any
time.
Protection Profiles Strict, Scan, Web,
Unfiltered
Control how the FortiGate unit applies
virus scanning, web content filtering, spam
filtering, and IPS.

Fortinet FortiGate FortiGate-3000 Specifications

General

Brand	Fortinet
Model	FortiGate FortiGate-3000
Category	Firewall
Language	English