Fortinet FortiGate FortiGate-3000 Install Guide

FortiGate-3000 and FortiGate-3600 FortiOS 3.0MR4 Install Guide
36 01-30004-0270-20070215
NAT/Route mode installation Configuring the FortiGate unit
Table 11: NAT/Route mode settings
DHCP or PPPoE configuration
You can configure any FortiGate interface to acquire its IP address from a DHCP
or PPPoE server. Your Internet Service Provider (ISP) may provide IP addresses
using one of these protocols.
To use the FortiGate DHCP server, you need to configure an IP address range
and default route for the server. No configuration information is required for
interfaces that are configured to use DHCP.
PPPoE requires you to supply a user name and password. In addition, PPPoE
unnumbered configurations require you to supply an IP address. Use Ta b l e 12 to
record the information you require for your PPPoE configuration.
Table 12: PPPoE
Administrator Password:
Internal
IP: _____._____._____._____
Netmask: _____._____._____._____
External
IP: _____._____._____._____
Netmask: _____._____._____._____
Port 1
IP: _____._____._____._____
Netmask: _____._____._____._____
Port 2
IP: _____._____._____._____
Netmask: _____._____._____._____
Port 3
IP: _____._____._____._____
Netmask: _____._____._____._____
Port 4
IP: _____._____._____._____
Netmask: _____._____._____._____
Port 4/HA
IP: _____._____._____._____
Netmask: _____._____._____._____
Port 5/HA
IP: _____._____._____._____
Netmask: _____._____._____._____
Network settings
Default Gateway: _____._____._____._____
(Interface connected to
external network)
A default route consists of a default gateway and the name of the
interface connected to the external network (usually the Internet).
The default gateway directs all non-local traffic to this interface and
to the external network.
Primary DNS Server: _____._____._____._____
Secondary DNS Server: _____._____._____._____
User name:
Password:

Fortinet FortiGate FortiGate-3000 Specifications

General

Brand	Fortinet
Model	FortiGate FortiGate-3000
Category	Firewall
Language	English