To Next Page

To Previous Page

TGA100 Rev0106

Change Preset Setting (Pressure or RPM)

The preset button allows the operator to go to a pre-programmed pump pressure

or engine RPM during operations. The setting will be shown on the PSI/RPM setting

display. This procedure is to change the setting in the program.

Note: The engine must be running and the pump engaged interlock circuit

must be closed (the OK TO PUMP LED must be on).

1. Press IDLE button.

Result: Display shows IdLE.

2. Press PSI or RPM mode button to select the setting to be changed.

Result: LED indicator goes on for mode selected.

Note: The RPM display must show IdLE before changing the preset.

3. Press and hold PRESET button. (Continue to hold through step 4.)

Result: PUMP DISCHARGE or RPM display flashes previous programmed

preset.

4. Press INC or DEC button to change preset setting.

5. Release PRESET button.

Result: The new preset is programmed. RPM display shows IdLE.

Questions and Answers:

Need help?

Do you have a question about the FRC InControl TGA100 and is the answer not in the manual?

FRC InControl TGA100 Specifications

General