TGA100 Rev0106
6
GENERAL DESCRIPTION
The INControl pressure governor and all-in-one instrument panel engine type
can be programmed form the facyory or or or during installation. (Refer to Programming
section.) It is compatible with the following engines:
TGA101/TGA201 Cummins IS Series
TGA102/TGA202 Detroit Diesel
TGA104/TGA204 Navistar
TGA105/TGA205 Caterpillar
TGA110/TGA210 Mercedes
All controls and indicators are located on the front of the control module.
Components
The information available on the J1587 databus varies depending on the particular
engine type. The sensors (if any) that need to be installed will also vary depending on
the engine.
The INControl pressure governor and monitoring display consist of the following
components:
Control Panel
Intake Pressure Sensor
Discharge Pressure Sensor
Audible Alarm Buzzer
Engine Coolant Temperature Sensor (As Necessary)
Engine Oil Pressure Sensor (As Necessary)
Transmission Temperature Sensor (TGA200 As Necessary)
Cables
Control Panel
The control panel is waterproof and takes up 9 3/4 by 4 3/4 inches of panel space.
All controls, indicators, and displays are located on the front of the control panel.
(Refer to Controls and Indicators.)
Intake Pressure Sensor
The pressure sensor is mounted on the pump intake manifold. It provides an input
signal to the control panel that is proportional to the intake pressure. (See Pressure
Sensor Calibration Note.)
To Next Page
Loading...
Need help?
General
