To Next Page

To Previous Page

TGA100 Rev0106

High Idle

The INControl programming includes a high idle function that is controlled by

the High Idle Switch.

To activate the high idle set interlocks as called for by SOP (normally this would

include the transmission in neutral and the parking brake on ). Set the High Idle switch

to ON.

Note: The pump must NOT be engaged when using the high idle

function and the OK TO PUMP LED will be off.

Change High Idle Setting

Note: The high idle is set at about 1000 RPM at the factory. (This value will

vary depending on the specific engine.)

1. With the engine running, set the high idle switch to ON.

Result: Engine RPM goes to high idle.

2. Press and hold PRESET button.

Result: RPM display will flash and show the high idle setting.

3. Press INC/DEC button to change the high idle RPM setting.

4. Release PRESET button to store the new high idle setting.

Questions and Answers:

Need help?

Do you have a question about the FRC InControl TGA100 and is the answer not in the manual?

FRC InControl TGA100 Specifications

General