2.3 About the Earth Fault Interrupter 39
2.3 About the Earth Fault Interrupter
The power cord set of the printer has an earth fault interrupter.
In the event of current leakage, the interrupter automatically shuts off the flow of electric
current to prevent any current leakage or fire from occurring.
If the interrupter trips (if the <RESET> button is popped up), press the <RESET> button. If
the interrupter trips again, contact our Customer Support Center or your dealers.
Once a month, switch the printer off and test if the interrupter is functioning normally. Using
a failed interrupter causes electric shock.
If your interrupter is not functioning normally, contact our Customer Support Center or your
dealers.
Refer to
• For information on how to test the interrupter, refer to " For Power & Earth Connection" (P. 12).
RESET button