Security functions
Removing passwords
To remove a password (without setting a new password) perform the following steps:
PasswordSupervisorpasswordUserpassword
► Start the B IOS Se tu p Utility and go to the Security menu.
► Highlight the Set Supervisor Password or Set User Password field and pre ss the Enter key.
You w ill be requested to enter the current password by the Enter Current Password prompt.
Enter New Password will appear and you will be requested to enter a new password.
► Press the Enter key twice at this request.
► In the Exit menu, select the option Save Changes & Exit.
► Select Yes and press the Enter key.
The Ta blet PC is rebooted and the password is removed.
Removing the supervisor password simultaneously deactivates the user password.
Password protectio
n for b ooting the operating system
With the supervisor password you have set in the BIOS Se tup Utility (see
section "
Assigning the supervisor and user password s", Page 58), you can
also prevent booting of the operating system.
Operating system
Activating system protection
► Start the B IOS Se tu p Utility and go to the Security menu.
Operatingsystem
► Select the PasswordonBootoption and press the Enter key.
► Select th e option you require (First Boot or Every Boot) and press the enter key
► Select the Save Changes & Exit option under Exit.
The Tablet PC reboots. You will be prompted to enter your password (th e supervisor password).
Deactivating system protection
► Start the B IOS Se tu p Utility and go to the Security menu.
Operatingsystem
► Select the PasswordonBootoption and press the Enter key.
► Select the Disabled option and p ress t he Enter key.
If you d o not want to change any other settings, you can exit BIOS Setup Utility.
► Select the Save Changes & Exit option under Exit.
The Ta blet PC reboots. The system is no longer password -protected.
Fujitsu 59
To Next Page
Loading...
Need help?
General