14 - English Getting started
Adjusting the rotation
► Grasp the Z ero Client’s monitor with bo th hands on the right and left edge o f
the casing and turn it to the desired position.
Adjusting portrait format
The Zero Client’s monitor
can be rotated from horizontal format (landscape
mode) to vertical format (
portrait mode).
► Grasp the Z ero Client’s m
onitor with both hands on the right and left edge of
the ca sing, tilt the moni
tor backwards, move it into the highest po sition and
turn it clockwise until
it is in the portrait position.
To be able to display the
screen contents in portrait m ode, the Zero Client Controller
software must support
this funct ion or you will need to use additional software.
To reset the monitor to landscape mode, th e monitor should be turned anti-clockwise.
The OSD display can be reset again in the OSD menu.
Fitting a swivel a
rm or wall bracket
Beforeyoucanuseaswivelarmorawallbracket,youmustfirst remove the base of the Zero Client.
The display surface of t he Zero Client is sensitive to pressure and scratches.
1
2
3
4
► Switch off the Zero Client and pull the
power plug out of the power socket.
► Remove a ll cables.
► Lay the Z ero Client on its front on
asoftsurface.
► Remove the screws (1-4) on the rear
of the Z ero Client.
Yo u can now mount a swivel arm or a wall
bracket in accordance with VESA FPMPMI
using a hole spacing of 100 mm.
For instructions on how to mount the swivel arm or wall bracket, please see
the documentation for the swivel arm or wa ll bracket.
16 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General