FM-8500
E4-3
Select "SIMP" or "DUP" and press the [ENT] key .
ENABLE= TX[1] RX[2] UN[3]
INTL CH:016 < TX SIMP HI >
ENABLE=TX[1] RX[2] UN[3]
ENABLE= TX[1] RX[2] UN[3]
USA CH:016 < TX SIMP HI >
TELECOM=SIMP[1] DUP[2]
INTL CH:001 < TX DUP HI >
TELECOM=SIMP[1] DUP[2]
USA CH:001 < TX DUP HI >
TELECOM= SIMP[1] DUP[2]
P01/ CH:001 < TX SIMP LOW >
P01/ CH:001 < TX SIMP LOW >
TX POWER= HIGH[1] LOW[2]
INTL CH:001 < TX DUP HI >
TX POWER= HIGH[1] LOW[2]
USA CH:001 < TX DUP HI >
TX POWER= HIGH[1] LOW[2]
*
The international channel setting display appears.
Rotate CHANNEL knob to a select channel to be set.
Press TX[1], RX[2], or UN[3] key, and [Enter] key depending on channel.
Rotate CHANNEL knob to select a channel to be set.
TX: Transmission and reception available
RX:Reception only
UN:Transmission and reception prohibited
Rotate CHANNEL knob to select a channel to be set.
Press TX[1], RX[2], or UN[3] key, and [Enter] key
depending on channel.
Rotate CHANNEL knob to select a channel to be set.
Press TX[1], RX[2], or UN[3] key, and [Enter] key
depending on channel.
TX: Transmission and reception available
RX:Reception only
UN:Transmission and reception prohibited
TX: Transmission and reception available
RX:Reception only
UN:Transmission and reception prohibited
Select communication mode.
Select communication mode.
Press SIMP[1] or DUP[2] key, and [Enter] key.
Press SIMP[1] or DUP[2] key, and [Enter] key.
Press HIGH[1] or LOW[2] key, and [Enter] key.
Press HIGH[1] or LOW[2] key, and [Enter] key.
Select communication mode.
Select TX power.
Select "HIGH" or "LOW" and press the [ENT] key .
Select TX power.
To set other INTL channels.
Rotate CHANNEL knob to select a channel to be set.
To set other USA channels.
To select other mode (USA, WX or Private),
Press the [CH16] key while pressing the a CHNNEL knob.
Press the [CANCEL] key.
*USA Channel mode
PRIV No.SELECT: [<] [>] key
P01/ CH:- - - < - - - - - - - ->
P01/ CH:001 <UNABLE>
Press the arrow key to select private channel
(P01 to P20) to be set.
Press the [ENT] key.
Select TX power.
Rotate CHANNEL knob to select a channel to be set.
To set other private channels.
*PRIVATE Channel mode
*INTL Channel mode
ENABLE= RX[1] UNABLE[2]
WX CH:001 < RX >
Rotate CHANNEL knob to select a channel to be set.
Press ENABLE[1] or UNABLE[2] key, and [Enter] key
depending on channel.
ENABLE:WX Reception
UNABLE:WX reception prohibited
Rotate CHANNEL knob to select a channel to be set.
To set other WX channels.
*WX Channel mode
(continued on next page)
System < Rom version >
V P ID DSC RT CH PO L
(From previous page)
(RT program Ver-06 and later)
To Next Page
Loading...
Need help?
General
