Furuno FM-7000 User Manual

FELCOM 82
H3-40
3.8.2 Connection to Internet service
If a number of the Internet service provider is available, access to an Internet web site.
1. Complete the Dial-up Networking setting; HSD modem and TCP/IC protocol.
2. Make sure that FELCOM 82 is in stand-by condition.
3. Call Service Provider
3.9 LED status
The LED status is tabulated in this section.
3.9.1 RF CON Board (16P0181)
Parts No. Color Status Item Remarks
CR5 GRN Blink
(Looks
like ON)
FSK RX
Monitor
This LES is used to check the
communication between the antenna
and the comm. units. The brightness of
the LED depends on FSK data from the
antenna unit.
CR6 GRN On TX ON This LED is on during TX and off during
RX.
CR7 RED Off TX PLL unlock This LED is on for a while at power up.
After the CPU board assigns the
channel to be use, LED goes off. The
LED should not be on continuously.
CR8 RED Off RX PLL1
unlock
(815 MHz)
This LED is on for a while at power up.
After the CPU board assigns the
channel to be use, LED goes off. The
LED should not be on continuously.
CR9 RED Off RX PLL2
unlock
(730 MHz)
This LED is on for a while at power up.
After the CPU board assigns the
channel to be use, LED goes off. The
LED should not be on continuously.
SNY UNLOCK IND
CR7: TX
CR8: RX1
CR9: RX2
CR6: TX ON
CR5: FSK Rx Motor

Furuno FM-7000 Specifications

General

Brand	Furuno
Model	FM-7000
Category	Marine Equipment
Language	English