FELCOM 82
H3-54
4.2.2 Using PC
To upgrade the system program by using a PC, follow the steps below.
1. Run the DOS on the PC.
2. Inset the floppy disk having new software into the drive.
3. Type A: and press [Enter] key. Prompt changes to A:¥>.
4. Type update command. For example, to upgrade SYSTEM program, type
UPSYS and press [Enter] key. The following data appears in turn.
A:
¥
>uppg load.bin syscpu.bin 0 0 200 1
Program upload utility Version 6.25
Copyright(c) FURUNO ELECTRIC CO.,LTD.1997,1998,1999(T.K)
uppg infile1 infile2 p1 p3 p2 p4 p5
p1:Deletion waiting time.
p2:Waiting time to write.
p3:Password output interval.
p4:ID number.
p5:Port number.(1,2...)
Erase Wait:0sec
Wait:o
Wait counter=200
Port no.=1
TARGET POWER ON.
5. Turn on the IB-282, if it is off. The program upgrading proceeds while the
indication “xxx percent completed” on the terminal unit.
6. Wait until the message “Finish version up” appears.
7. Turn off the IB-282.
8. Turn on the IB-282 to check the program revision level.
9. After updating the SYSTEM program, clear RAM contents.
4.2.3 After upgrading SYSTEM (RAM clear)
After upgrading SYSTEM program, clear RAM contents by using the terminal unit or
the handset.
The contents in the memory are listed in chapter 1.
1) By using terminal unit
To clear RAM contents;
1. Press [F4] [6] to call Communication Setup menu.
2. Type CLR (space) RAM on the “Enter JOB No.” line and press [Enter] key.
3. Type DENPA4 on the “Password” line and press [Enter] key.
4. Wait for a while so that the status display is redrawn.
To Next Page
Loading...
Need help?
General
