K1-6
Note) Rewriting the memory
If you press [F1] key when a message "Hit <F1>, if you want to setup FLASH Disk."
appears before PC-DOS starts up after power-on, a memory settings display will appear. If
you "Save" the settings by pressing [F4] key, the terminal program will be deleted and will
not start. Then, a message "Boot Failure Insert BOOT diskette in A: Press any key when
ready" will appear. In this case, it is necessary to PC-DOS system files and terminal
program in A-drive.
Explain to customer that you do not touch keyboard after the power switch ON until
terminal software starting up completed.
Power ON
"Hit <F1>, if you want to setup FLASH Disk"
If press [F1] key, apper as follow.
If press [ESC] key, If press [F4] key,
FLASH type=29C040A(512k x 8) Total chip(s)=02 Disk size=1024 kbyte(s)
ESC:Exit F4:Save :Select PgUp/PgDn:Modify
"Write to FLASH disk(Y/N)" will appear on the screen.
Press [N],[Enter] keys. If you press [Y],[Enter] key :
AMIBIOS System Configuration (C) 1985-1995, American Megatrends Inc,.
Main Processor :i386SX Base Memory Size :640kB
Math Processor :None Ext.Memory Size :128kB
Floppy Drive A: ::None Display Type :VGA/EGA
Floppy Drive B: :1.44MB 31/2 Serial Port(s) :3F8.2F8
AMIBIOS Date :07/15/95 Parallele Port(s) :378
Processor Clock :33MH
The displays depend upon CPU Card Version.
(The above is for Ver. 3.0.)
Note) This is the memory configuration of IB-581.
Do not change this.
note)
"Starting PC DOS..."
PC DOS will not starting.
If power is turned on, PC-DOS will not start
keeping the display below.
"Boot Failure Insert BOOT diskette in A:
Press any key when ready."
Starting terminal program
IB-581
To Next Page
Loading...
Need help?
General
