9. ROUTES
9-9
Context sensitive menus
A context-sensitive menu for setting the
draught is available on the [Alert Parameters]
page. Right-click [Draught] to show the menu.
[Set “ALL” setting to all legs] applies the draught value of [Check type: All Legs] to all
legs. [Clear setting] restores default settings for each leg.
9.4.5 How to use the Check Results page
The [Check Results] page allows you to make safe water calculation for your route.
Click the [Check Route] button to do the check. After the button is operated, the alert
type and latitude and longitude position of the alert appear for applicable legs on the
route.
Note 1: In order to display charts with correct updated situation, always use current
date during your voyage. If your voyage lasts more than one week, set current date at
least once per week during your voyage.
Note 2: A route check can take longer with C-MAP charts. Wait until the completion
of the check.
Note 3: After a chart update (including installing charts) is done, redo the route check
(with [Check Route] button) on a route before using it for navigation, to confirm that
the route is safe against updated charts. Also redo a route check whenever another
unit in the network has updated charts while monitoring a route. When you attempt to
use the instant track feature without doing a route check, the message “Not checked
against ENC chart” appears in the permanent warning dialog box.
Permit
Expired
Permit for chart has expired. Not Up-to-date Chart not up to date.
Item Description Item Description
Set “ALL” setting to all legs
Clear setting
Route Bank
To Next Page
Loading...
Need help?
General
