14. AIS TARGET FUNCTIONS
14-8
14.6 Activated Targets
When you change a sleeping target to an activated target, the target’s course and
speed are indicated with a vector. The vector can be monitored to find vessel move-
ment.
To activate a sleeping target, put the cursor on the target then press the ACQ/ACT
key.
When the screen gets full of activated targets, it is difficult to discriminate the radar
display and tracked targets. When this occurs, sleep some activated targets to clear
up the screen.
14.7 Sleeping Targets
14.7.1 How to sleep an activated target
Put the cursor on an activated target, then click the TARGET/CANCEL key.
14.7.2 How to sleep all activated targets
1. Open the [Overlay/NAV Tools] box, the right click [AIS].
2. Click the [Set] button of [Sleep All Targets].
3. Click the [Save] button to save settings. Click the [Close] button to close the dialog
box.
Rate of Turn (ROT)
Heading line *
2
Speed over ground (SOG),
Course over ground (COG) vector
*1
For water tracking mode, speed thru the
water (STW) and course through the water
(CTW) are shown.
*2
COG shown when there is no heading
data.
To Next Page
Loading...
Need help?
General
