1. INITIAL SETTING AND ADJUSTMENT
1-33
4. Click the [Details] button to open the [Details Setting] window and enter the appro-
priate items.
• [Equipment Name]: Enter the name of the
HUB.
• [IP Address]: Select the network and IP
Address of the HUB from the pull-down list.
• [Community]: Set the parameters for
SNMP protocol. This setting must be the
same as set at the HUB.
5. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.4.8 Signal and Port setting for external equipment
This connection setting menu can set the serial I/O for external equipment, the analog
input for Sensor Adapter, and HUB port.
1. Click [Connection Setting] on the menu bar.
2. Click [Serial Input/Output Setting] on the menu bar.
The serial input/output settings are shown. The settings can be changed, referring
to step 6 of section 1.4.2.
3. Click [Analog Input Setting] on the menu bar.
The analog settings are shown. The settings can be changed, referring to step 12
of section 1.4.4.
4. Click [HUB Setting] on the menu bar.
The alert settings of each port of the HUBs are shown. The display is changed ac-
cording to the [Monitoring Type] setting. For details of [Monitoring Type], see
page 1-32.
To Next Page
Loading...
Need help?
General
