Furuno FS-2550 User Manual

DP-6
D2-5
F6: Menu description
Timing values depend on the transceiver connected. Therefore some trial and
error may be necessary to find suitable values.
*MIF Tune
Turn on to send ATU tuning command.
*Freeze
Turn on to send “freeze” command to radio equipment connected.
*AGC
Turn on to automatically control gain in telex mode.
(FS-1500 series RT is not supports AGC command.)
*Emission
Turn on to automatically change mode at RT to telex.
*Tx/Rx MSG Save
Turn on to automatically save incoming and outgoing message to FDD.
*Edit before sending
“No” transmits keying operation one by one. “Yes” transmits message only
when the [Enter] key is pressed after confirming text typed.

Furuno FS-2550 Specifications

General

Power Output	150W PEP
Tuning Steps	10 Hz
Power Supply	13.8 VDC
Frequency Range (Transmit)	1.6 - 27.5 MHz
Frequency Range (Receive)	0.1-30 MHz
Emission Modes	J3E, H3E, F1B, A1A