FS-75/2550
A2-10
Power data setting table
Note)
Power data for user channel is commonly used for all classes of emission.
The table below shows output power calculated from power data when 50 ohms dummy
load is connected to the transceiver unit. Reference only.
Condition) 4MHz SSB, Single tone (whistling into the handset)
Power data 255 240 220 200 180 160 140 120 100 80 60 40 20 10 0
150W 180 178 153 132 112 92 76 61 48 34 23 18 15 8 8
Output
Power
250W
150:
345
320 260 200 160 115 80 50 35 25
To Next Page
Loading...
Need help?
General
