FELCOM 81
H2-11
3.5 Terminal settings
1. Entering AAB
Press [F4], [3] and [8] in this order at normal display.
Enter your ship’s answer back code given by Inmarsat, the press the [Enter] key.
Normally, answer back code consists of telex IMN given by Inmarsat and four
characters your applied to Inmarast for.
EX) TELX IMN No. 4characters X
343164830 JFKS X
Note) Reentering AAB
1. Press [F4], [3] and [8] in this order at normal display.
2. While pressing and holding down both the [Alt] and [Ctrl] keys, enter cipher code;
[A] [N] [S] [W] [E] [R]
The AAB stored in the memory is erased.
2. OID/DID Settings
OID,DID settings are entered through the commissioning menu on the Communication
Unit Setup menu. The commissioning menu can be displayed in two ways: by entering a
command or changing the setting of a DIP switch.
Case-1) Displaying the commissioning menu by commands
1. At the standby display, press [F4] [6] to display the Communication Unit Setup menu.
2. Type FURUNOSERVEICE as the Job No.:
[F][U][R][U][N][O][S][E][R][V][I][C][E]. Press [Enter] key.
3. Type FELCOM81 as the password:[F][E][L][C][O][M][8][1]. Press the [Enter] key.
4. Go to the Communication Unit Setup menu and press [6] and the [Enter] key to
display the commissioning menu. Go to item case-2)-3 in next page.
!
!! ATTENTION: CAN NO
To Next Page
Loading...
Need help?
General
