Furuno FS-2550 User Manual

K1-1
AR-B1374
1. How to Quit Programs
When updating the program of each terminal unit, quit the program, and then switch to the
screen in which the PC-DOS prompt such as "A:¥-----" is displayed. The table below
summarizes how to quit the terminal program for each terminal.
Changing to PCDOS Display
How to confirm
program version
Installation
command
Terminal
unit
B:¥>install
DP-6
Main
unit
[Alt]+[Fn]=>[F2]
Note)With the version Ver-15 or earlier
[Fn]+[F2]
A:¥DP10¥
TERMINAL>
[F6]=>Self test
B:¥>nbdpinst
[F1]=>nbdp.exe
FELCOM 11 [F1] =>[8]
A:¥
FELCOM11>
Confirm at
program starting
B:¥>ibinst
FELCOM 12 [Alt]+[Fn]=>[F2]=>YES=>[Enter]
A:¥
FELCOM12>
Ver03:
[Alt]+[Fn]=[F1]
B:¥>ibinst
FELCOM 81 [Alt]+[Fn]=>[F2]=>YES=>[Enter] A:¥> [Alt]+[Fn]=[F1] B:¥>ibinst
For example, to quit the terminal program of FELCOM-12:
- Press [F2] key while pressing [Alt] and [Fn] keys.
- A message, "OK to quit system Yes/No", will appear. Then, move the cursor to "Y",
and press [Enter] key.
- Then, the prompt, "A:¥FELCOM12>", will appear on the screen.
To update the terminal program, B-drive (B:¥>) is used. To change from A-drive to B
drive,
- press [B],[:], and [Enter] keys successively.
Then, the prompt, "B:¥>", will appear on the screen.
Type “installation command”, then press [Enter] key. (See above table; installation
command.)
Section K1. IB-581
Note) Drives of IB-581 are:
A drive : Flash ROMs of IB-581
B drive : Floppy disk
CPU card

Furuno FS-2550 Specifications

General

Brand	Furuno
Model	FS-2550
Category	Marine Equipment
Language	English