FELCOM 82
H3-47
Call failure error message (con’t)
Error Message Reason Remedy
Call failed, LES congested (no channel unit). (5713)
Call failed, terrestrial circuits congested. (5201)
Call failed, LES congested (no channel and no circuit). (5202)
Call failed, LES congested (no channel). (5457)
Call failed, LES congested (no time-slot). (5458)
Call failed, terrestrial party busy. (7953)
Call failed, terrestrial circuit failure. (8033)
Call failed, terrestrial party cleared before MES
connection.(8034)
Call failed, set-up between LES and terrestrial circuits failed.
(7265)
• Line is busy.
• Line trouble.
Try again a little
while later.
Call failed, MES not authorised at this LES. (5537)
Ship’s answerback code not
properly entered.
Checking
OID/DID
Call failed, Distress call in progress. (0062)
Call of higher priority in
progress.
Try again a little
while later.
Call failed, MES busy. (0060)
MES not ready for
communications.
Try again a little
while later.
Call failed, MES terminal not enabled. (0061)
MES not ready for
communications.
Setting: Incoming
only OFF
Call failed, antenna circuit abnormality. (0032)
Call failed, no channel assignment received from LES. (0033)
Call failed, invalid power level assignment. (0034)
Call failed, RX DEMOD circuit abnormality. (0035)
Call failed, TX MOD circuit abnormality. (0036)
Call failed, TX-RF circuit abnormality. (0038)
Call failed, Selectively cleared by LES. (0039)
Call failed, MES unable to sync. to NCSA in time. (0041)
Call failed. (0042)
Equipment trouble*
* = Another error message accompanies these messages and is printed
out. Trouble can be determined from the printout.
Note 1: Number in parentheses is error message number.
Note 2: Wait 30 seconds before calling again.
To Next Page
Loading...
Need help?
General
