IB-582
K2-3
9. Follow the instruction message on the screen until A:\> appears. If you accept the displayed
data, press [Enter] key.
Current data is Sat x
–
xx-xxxx
Enter new data (mm-dd-yyyy):
Current time is xx:xx:xx.xx
Enter new time:
Datalight ROM^DOS Version 6.22
Copyright © 1989-1999 Datalight, Inc.
A:\>
10. To copy files on the floppy disk (drive A) to the flash ROM (drive C), type FORMAT C:/S,
followed by [Enter] key.
11. Press [Y], followed by [Enter] key while the message below is on the screen.
Warning ! All data on hard disk drive C: will be lost !!
Are you SURE you want to format this drive (Y/N) ? Y
12. Wait until the format is completed.
13. Change the drive from A to C. (Type C:, followed by [Enter].)
14. Type DIR, followed by [Enter] key to make sure that COMMAND.COM file exists in the
flash ROM.
15. Change the drive from C to A.
16. Type COPY FORMAT.COM C:, followed by [Enter] key to copy the file to the flash
ROM.
17. Change the drive from A to C and type DIR, followed by [Enter] key to make sure that the
flash ROM has COMMAND.COM and FORMAT.COM files.
18. Remove the floppy disk and insert the floppy disk having FELCOM 82 terminal software.
19. Change the drive to A.
20. Type INSTALL, followed by [Enter] key.
21. After the program is installed, turn off the unit and remove the disk.
22. Follow steps 1 to 3 above and change the settings as below.
(1) Quick Boot: from Disabled to Enabled
(2) Boot UP Sequence: from A:, C:, CDROM to C:, A:, CDROM.
To Next Page
Loading...
Need help?
General
