also be displayed each time you turn the GPS 100 on as long as the overlap
remains. (WARNING: If you enter the overlap area, the unit will only inform
you of the nearest proximity waypoint.)
To remove a waypoint from the proximity list...
· Place the cursor over the waypoint name you wish to delete.
· Press the CLR key, the waypoint name will blank.
· Press the ENT key, the waypoint will be removed from the proximity
waypoint list.
4.9 Waypoint Catalog
Route Use Waypoint Names
Number of User
Proximity Use Waypoints
WAYPOINT CATALOG PAGE
The Waypoint Catalog Page displays up to six waypoints in alphabetical
order. Additional waypoints are viewed by scrolling through the waypoint list.
The status of a waypoint is displayed immediately to the left of the waypoint
name. The status consists of the first route number (0..9) in which the
waypoint is used (if any), and an asterisk “*” if you entered the waypoint in
the proximity list. For example, waypoint OILRG is a proximity waypoint, and
waypoint OKLND is used in route 2.
A total of 250 waypoints can be permanently stored in memory. The number
of waypoints you have defined is shown in the upper right-hand corner of the
page.
To scroll through the waypoint list...
· Place the cursor over the last waypoint name on line 3 and press the
4-9
To Next Page
Loading...
Need help?
General
