When the selected alarm time has been reached, the GPS 100 will
automatically inform you with the message “ALARM CLOCK 1” or “ALARM
CLOCK 2”.
To cancel an alarm clock...
· Press the CLR key to select “OFF” for the alarm clock.
10.3 EVENT TIMERS
Time
Timer Select
EVENT TIMER PAGE
The GPS 100 features two timers available on separate pages. Each can be
used as either an elapsed timer or count down timer. These timers can be
useful for measuring the elapsed time since a certain event, or they can tell
you when a specified amount of time has expired.
To set the count down timer...
· Move the cursor over the cyclic field on line 3 and press the CLR key
until “COUNT DOWN” is displayed.
· Enter the count down time in hours, minutes, and seconds. The cursor
will automatically move to “START?”.
· With the cursor over “START?”, press the ENT key. The timer will start
counting down.
When the count down timer reaches 0, you will be informed with the message
“TIMER 1 EXPIRED” or “TIMER 2 EXPIRED”, and the count down timer will
begin to count up showing you the elapsed time since the timer has expired.
You may stop the count down timer at any time. When stopped, the count
down time will freeze at its last value.
To stop the count down timer...
10-3
To Next Page
Loading...
Need help?
General
