Garmin © 2007 60 Honda Portable Navigation System
aPPendix
USB Interface Troubleshooting
Problem/Question Solution/Answer
How do I know my unit
is in USB Mass Storage
Mode?
When your unit is in USB Mass Storage Mode, a picture of a Honda
Portable Navigation System connected to a computer is shown. Also,
you should see a new removable disk drive listed in My Computer
(Windows) or a new volume (drive) on your desktop (Mac).
My computer does not
sense that the unit is
connected.
1. Unplug the USB cable from your computer.
2. Turn the unit off and then back on again.
3. Plug the USB cable into your computer. The unit automatically
turns on and goes into USB Mass Storage Mode.
I cannot nd any drives
named “nuvi” in my list
of drives.
Try the solution listed above.
If you have several network drives mapped on your computer,
Windows may have trouble assigning drive letters to your nuvi drives.
Follow the steps on the following page to assign your drive letters.
Verify that your computer has the latest updates installed. If not,
update your computer, and then connect the unit.
I keep getting a message
saying “Unsafe Removal
of Device” when I unplug
the USB cable.
Windows users, double-click the Unplug or Eject icon in your
system tray. Select “USB Mass Storage Device” and click Stop. Select
the nuvi drives and click OK. You can unplug your unit from your
computer now.
Mac users, drag the volume icon to the Trash . The Trash icon
changes to an Eject icon.
To Next Page
Loading...
Need help?
General
