– 43 –
Oven Door Assembly
The oven door can be separated into 2 assemblies.
The outer door assembly consists of the outer
panel, reinforcement plate, and a replaceable door
handle. The inner door assembly is made up of the
inner panel, inner glass assembly, retainers, heat
barrier, door gasket, and replaceable door hinge
assemblies.
To remove the lower outer door assembly:
1. Remove the door. (See Oven Door Removal.)
2. Place the door assembly on a protective surface
with the gasket side up.
3. Remove the four 1/4-in. hex-head screws from
the bottom of the outer door assembly.
Note: The inner door assembly is heavier than the
outer door assembly.
5. Separate the inner door assembly from the
outer door assembly.
To remove the lower oven door:
1. Open the door fully.
2. Pull the hinge locks back to the unlocked
position. A tool, such as a small fl at blade
screwdriver, may be required.
Hinge Door Lock
3. Close the door 45 degrees until the hinge lock
rests on the door frame.
4. Lift the door up and out until the hinge arm
clears the slot.
5. Place the door assembly on a protective
surface.
4. Remove the two T-15 Torx screws and washers
from the inner door assembly.
(Continued next page)
To Next Page
Loading...
Need help?
General