To Next Page

To Previous Page

– 56 –

Bake Burners and Glow Bar Igniters

To check the resistance of the bake burner glow bar

igniter on Café models, remove the rear cover. (See

Rear Cover.) The glow bar igniter has an approximate

resistance value of 233 at room temperature.

An open measurement indicates an open valve

winding, bake igniter, or open wiring.

The resistance of the bake burner glow bar igniter

on Proﬁ le and GE models can be checked on the

ERC. Place the control panel in the service position.

(See Touch Panel and Electronic Range Control (ERC).)

Check for the approximate resistance value of 228

. An open measurement indicates an open valve

winding, open bake igniter, or open wiring.

Upper Oven

To remove the bake burner and replace the glow

bar igniter:

1. Remove the oven door. (See Oven Door Removal.)

2. Remove the rear cover. (See Rear Cover.)

3. Remove the two 1/4-in. hex-head screws (1 on

each side) from the oven ﬂ oor cover.

4. Grasp the oven ﬂ oor slots, lift the rear of the

oven ﬂ oor cover, then slide the cover forward

and remove it from the oven cavity.

Bake Assist

A bake assist element is used on all Café models

and some Proﬁ le models. It is located in the lower

oven.

To remove the bake assist:

1. Remove the oven door. (See Oven Door Removal.)

2. Remove the rear cover. (See Rear Cover.)

3. Disconnect the 2 wires from the rear of the bake

assist.

4. Remove the four 1/4-in. hex-head screws and

the bake assist.

Disconnect

(Continued next page)

1 on each side.

Bake Assist

GE C2S985 User Manual

Questions and Answers: