gefran ADV200 Instruction Manual

Flying Shear for Roll Forming machines – Instruction manual Pag. 12 / 29
The following drive configurations are required:
• Basic parameters configuration
• Digital I/O
• Encoders
• Field bus
4.2.1 Basic parameters configuration
After loading the default application parameters (Load default, PAR 11100), the basic drive parameters are
configured.
Table 2 shows the configurations loaded.
PARAMETER
SETTING
PAR
MENU
PARAMETER
552
DRIVE CONFIG
Regulation mode
Flux vector CL
556
DRIVE CONFIG
Control mode select
Speed
752
RAMPS
Ramp out zero src
One
650
REFERENCES
Dig speed ref 2
Dig spd ref1
1000
COMMANDS
Commands remote sel
Digital
1004
COMMANDS
Enable/disable mode
Off
1010
COMMANDS
Commands safe start
On
1018
COMMANDS
Digital Enable src
Pad 1
1020
COMMANDS
Digital Start src
Pad 1
1022
COMMANDS
Fast Stop src
Off
1314
DIGITAL OUTPUT
Digital Output 3 src
Pad 2
4452
WORD DECOMP
Word decomp src
Dig word decomp
4500
ALARM CONFIG
Fault reset src
Null
Table 2: Parameters loaded using Load Default

gefran ADV200 Specifications

General

Brand	gefran
Model	ADV200
Category	Inverter
Language	English