Flying Shear for Roll Forming machines – Instruction manual Pag. 7 / 29
2.1 Application key
This application must be registered.
Register by entering a code supplied by Gefran.
Enter the code as follows:
• Connect to the drive using the GF_eXpress configurator or read the parameter indicated in the next point
using the keypad.
• Write down the Serial Number indicated in Regulation S/N (PAR 12106, ROLL FORMING FS \ About
menu).
• Contact Gefran support and provide the serial number you just read to obtain the application unlock
key.
• Enter the unlock code in the Application key parameter field (PAR 572, CONFIG DRIVE menu).
To Next Page
Loading...
Need help?
General