To Next Page

To Previous Page

Flying Shear for Roll Forming machines – Instruction manual Pag. 5 / 29

1 Introduction

1.1 Information about this manual

This document describes the Flying Shear for Roll Forming machines software, supplementing what is

described in the ADV200 drive manual (for asynchronous and synchronous motors) and the optional boards

for encoder acquisition and input expansion.

1.2 Drive Firmware / Application version Cross compatibility

Flying Shear for Roll Forming machines Application ADV200 Firmware

1.x.1 7.5.16 and higher

1.3 Symbols used in the manual

Indicates a procedure, condition, or statement that, if not strictly observed, could result in personal

injury or death.

Indicates a procedure, condition, or statement that, if not strictly observed, could result in damage to

or destruction of equipment.

The following operations require the machine in motion.

Unforeseen machine movement is always possible. Take this into account and take the necessary

precautions.

Indicates that the presence of electrostatic discharge could damage the appliance.

When handling the boards, always wear a grounded bracelet.

Indicates a procedure, condition, or statement that should be strictly followed in order to optimize

these applications.

Note !

Indicates an essential or important procedure, condition, or statement.

gefran ADV200 Instruction Manual

Other manuals for gefran ADV200