Gerber Technology GERBERplotter Infinity Series User Manual

21
English
Software Installation
1. Close any programs that are open.
2. Insert the Infinity Interface CD into your CD ROM drive.
If the install procedure does not start automatically,
perform the following:
a) Go to the Start menu and select Run.
b) Type n:\setup, where n is the CD Rom drive
letter.
c) Select OK
3. When the Welcome to the Gerber Technology Infinity
Installation window opens (Figure 12), click on the Install
Infinity Software link and follow the on-screen prompts to
complete the software installation.
Note: If WinPlot software cannot be found by the
install program and you are using AccuMark, disregard
the Warning (Figure 13). If you are using WinPlot, it can
be installed later.
Figure 12. Infinity Installation Screen

Gerber Technology GERBERplotter Infinity Series Specifications

General

Brand	Gerber Technology
Model	GERBERplotter Infinity Series
Category	Plotter
Language	English