Gerber Technology GERBERplotter Infinity Series User Manual

33
English
Paper Installation
Paper Supply Roll
1. Place the paper roll (3) in front of the plotter with the
leading edge positioned as shown (Figure 22):
Note: A 30 yard roll of paper for test and diagnostics
is included with the plotter.
2. Insert the paper supply mandrel (3) though the paper roll
(4) from the right side.
3. Install an adjustable (6) on the left end of the mandrel to
secure the paper roll on the mandrel.
4. Set the mandrel ends in the front rollers (2), one end at a
time. Push the paper roll back until the mandrel ends are
aligned on the rear rollers (1).
5. Close the bail (5) on each end of the mandrel.
6. Hand-tighten the bail knob (7) on the ends of the
mandrel.
Figure 22. Paper Supply Roll Installation
Key to Figure
1-Rear Roller, 2-Front Roller, 3-Paper Mandrel, 4-Test Roll of Paper,
5-Bail, 6-Adjustable Hub, 7-Bail Tension Knob
1
4
3
2
6
7
5

Gerber Technology GERBERplotter Infinity Series Specifications

General

Brand	Gerber Technology
Model	GERBERplotter Infinity Series
Category	Plotter
Language	English