To start the engine, it is advisable to shift the
gears and the PTO shuttle to the neutral position
and leave the Gear Stop
lever in the raised
position so as to disengage the clutch.
STARTING AND STOPPING THE
ENGINE
Before starting the engine
WARNING
For machine with an electric starter:
Do not start the engine without having
positioned and properly connect the
battery to prevent damage to the
voltage regulator.
●
Insert the key and turn it as described
below:
Each starting attempt should last for just a few
seconds.
Do not make consecutive attempts to start the
engine without having waited at least 20 sec.
between one attempt and the next, otherwise the
battery will quickly run down and the starter motor
could be damaged.
After the engine has started:
●
Release the key. It will automatically return
to the operating position
Insert the key and turn it clockwise to
the first position (the electrical circuit
will be powered).
WARNING
Do not keep operating the starter motor
when the engine has already started.
Damage to the starter motor due to
failure to comply with these
instructions will not be covered by the
warranty.