Cleaning Procedure
313289W 25
Cleaning Procedure
1. Ensure all equipment is grounded. Follow the
Grounding procedure on page 15.
2. Ensure the area where the sprayer will be cleaned
is well ventilated; and remove all ignition sources.
3. Turn off all heaters and allow equipment to cool.
4. Flush mixed material. Follow the Flush Mixed
Manifold, Hose, and Spray Gun procedure on
page 18.
5. Relieve pressure. Follow the Pressure Relief
Procedure on page 17.
6. Shutdown sprayer and turn off all power. Follow the
Park Fluid Pump Rods procedure on page 24.
7. Clean external surfaces using only a rag soaked in
solvent that is compatible with the spray material
and the surfaces being cleaned.
8. Allow enough time for solvent to dry before using
sprayer.
9.
To Next Page
Loading...
Need help?
General
