60 / 81 EN
Television / User Manual
NETWORK SETUP
-------------------------------------------------------------------------------------------
You can launch various applications on the Ap-
plication Portal. These applications include vari-
ous types such as video, picture, music, game,
social networking applications, news and sports
applications, weather forecast applications.
Network connection
You can establish a wired or wireless connection
between your television and the local network.
If you want to use a wired network connection,
please start with the instructions here:
If you use a wireless network connection, please
follow the instructions in the "Wireless network
connection" section on page 62.
Note:
7
The following section describes connecting
to the home network if you did not carry this
out during the “initial set-up”.
Wired network
Wired network connection
1 Connect the output of external modem to
LAN socket with Cat 5 cable.
Note:
7
Connection cables are not supplied.
Wired network settings
There are two ways of making the wired net-
work settings.
A Automatic connection,
all data regarding connection settings (»IP
Address«, »Netmask«, »Gateway« and
»DNS«) are obtained from modem auto-
matically.
B Manual connection,
all data regarding connection settings (»IP
Address«, »Netmask«, »Gateway« and
»DNS«) must be configured manually.
Automatic connection
Most of the home networks are Dynamic. If you
have a dynamic network, you must use a DSL
modem that supports DHCP. Modems and IP
sharers that support DHCP obtain the »IP Ad-
dress«, »Netmask«, »Gateway« and »DNS«
values required for internet access automatically,
and thus you are not required to enter those
values manually.
1 Open the menu with »MENU«.
2 Press »
V
« or »
Λ
« to select »Network« and
press »
>
« to confirm.
3 Press »
V
« or »
Λ
« to select »Wired Net-
work« and press »OK« to confirm.
4 To approve the Privacy Policy, press »
<
« or
»
>
« to select »Accept« and press »OK« to
confirm.
5 According to your network infrastructure,
press »
V
« or »
Λ
« to select »IPv4« or
»IPv6« and press »OK« to confirm.
Note:
7
To access the internet through IPv6, your
internet service provider and modem must
support IPv6. If only the modem supports
IPv6, it can only connect to the modem; you
cannot connect to internet.
6 Press »
V
« or »
Λ
« to select »Auto Input«
and press »OK« to confirm.
– »Connecting ... « message will be dis-
played and if the connection is success-
ful, »Connect Success« message will be
displayed.
To Next Page
Loading...
Need help?
General