Dialock Door Terminals DTSH, DTSH FH - Status: 07.2008 - 732.29.134
63
English
Installation Instructions
Start-up
The Dialock DTSH door terminal is supplied in so-called "simple mode"
for standalone operation (SA). This is the only operating mode that is
described in these instructions. Details about the use of the DTSH in con-
junction with software applications (Dialock HOTEL, PERSONNEL, hotel
management systems etc.) can be found in the relevant documentation.
Prevent use of user keys by unauthorised persons.
Keep the programming and clearing keys in a safe place, since lock-
ing authorisations can be allocated to and withdrawn from a user key
with these two keys.
The programming and clearing keys must be assigned as follows during
initial start-up:
This step is only possible after switching on for the first time.
Perform the initial start-up quickly and without interruptions!
Have green programming key and red clearing key ready.1.
Present the green programming key to the control panel until the blue 2.
LED is permanently on. An acoustic signal will be heard.
Remove programming key: Red LED flashes.3.
Present red clearing key to the control panel whilst red LED is flashing.4.
To Next Page
Loading...
Need help?
General
