55
HDE 16.05.2022 732.22.110
8.3 Set open time / set permanent deadbolt lock operation
Prerequisites: Programming key card Clearing key card
1. Hold the programming key card in front of the
antenna.
Acoustic signal is heard. LED quickly flashes
green for max. 5 seconds.
2. Hold the clearing key card in front of the
antenna.
Acoustic signal is heard. LED continues to
flash green quickly.
3. Hold the clearing key card in front of the
antenna again.
The acoustic signal is heard at one second
intervals.
LED flashes green in parallel to the acoustic
signal every second (max. 30 seconds).
4. Remove clearing key card after the required
time.
LED switches off.
The open time is set for the lock and all
authorised user keys.
The open time can be adjusted at any time, and is also retained after a power supply
interruption or a simple reset.
The open time can be extended to beyond 30 seconds using a macro with the
MDU 110 mobile programming unit with special functions (
3.2 Technical data, page
41).
After a complete reset or setting the terminal to "permanent deadbolt lock operation",
the set open time is deleted and the factory setting of 3 sec. or the deadbolt lock
operation is active.
If the clearing key card is held out only briefly (< 1 sec.), the terminal switches to
permanent deadbolt lock mode. With the presence of an authorised user key, the
terminal changes its locking status (permanently open or permanently closed).
If permanent deadbolt lock operation is no longer required, an open time must be set.
Tag-it ™ISO
5 s
1x/s 1x/s
ins-src-732.22.110_EFL.book Seite 55 Montag, 16. Mai 2022 9:28 09
ins-src-732.22.110_EFL - Kopie.pdf 55 16.05.2022 10:20:14
To Next Page
Loading...
Need help?
General
