Harman P42i-TC Installation Manual

Harman® • P42i Pellet Insert Installation Manual • 2023 -___ • 08/234 8742-901D
A. Appliance Certication
B. Glass Specications
This appliance is equipped with 5mm ceramic glass.
Replaceglassonlywith5mmceramicglass.Pleasecontact
your dealer for replacement glass.
C. Manufactured Home Approved
This appliance is approved for manufactured home
installations when not installed in a sleeping room and when
an outside combustion air inlet is provided.
The structural integrity of the manufactured home oor,
ceiling, and walls must be maintained. The appliance must
be properly grounded to the frame of the manufactured
home using a minimum of 8 AWG copper solid or stranded,
insulated or bare wire or equivalent and use only listed pellet
vent,Class“PL”connectorpipe.
AHarman®OutsideAirKitmustbeinstalledinamanufactured
home installation.
NOTE: This installation must conform with local codes.
Intheabsenceoflocalcodesyoumustcomplywiththe
ASTME1509,ULC-S628& (UM) 84-HUD
MODEL: P42i-TCPelletInsert
LABORATORY: PFS•TECO
REPORT NO.
F22-858
TYPE: PelletFueledInsert/Supplementary
ForResidentialUse
STANDARD(s): ASTM E2779-10, ASTM E2515-11,
ASTME1509-22,CAN/ULC628:2022,
CSAB415.1:22
D. BTU & E󰀩ciency Specications
1 1
Product Specic and Important Safety Information
The P42i-TC Pellet Insert is certied to
comply with 2020 EPA particulate emission
standards.
T H E S T R U C T U R A L I N T E G R I T Y O F T H E
MANUFACTURED HOME FLOOR, WALL, AND
CEILING/ROOF MUST BE MAINTAINED.
CAUTION
DO NOT INSTALL IN SLEEPING ROOM.
WARNING
* Weighted average LHV e󰀩ciency using data collected
during EPA emissions test.
**Weighted average HHV e󰀩ciency using data collected
during EPA emissions test.
***ArangeofBTUoutputsbasedonEPADefaultE󰀩ciency
and the burn rates from the low and high EPA tests.
****Basedonthemaximumfeedrateperhourmultipliedby
approximately8600BTU’swhichistheaverageBTU’sfrom
a pound of pellets.
Thiswoodheaterhasamanufacturer-setminimumlowburn
ratethatmustnotbealtered.Itisagainstfederalregulations
to alter this setting or otherwise operate this wood heater
in a manner inconsistent with operating instructions in this
manual.
This wood heater needs periodic inspection and repair for
properoperation.Itisagainstfederalregulationstooperate
this wood heater in a manner inconsistent with operating
instructions in this manual.
EPA Certication Number: 344-23
EPA Certied Emissions: 1.0g/hr
*LHV Tested E󰀩ciency: 84%
**HHV Tested E󰀩ciency:
79%
***EPA BTU Output: 5,637-32,782
****BTU Input 7,400 – 41,800
Vent Size: 4Inch
Hopper Capacity: 64.5 lbs
Fuel Wood Pellet
Note: Thisinstallationmustconformtolocalcodes.Inthe
absence of local codes you must comply with the ASTM
E 1509-2012, ULC S628-93, (UM) 84-HUD
Note: Hearth&HomeTechnologies,manufacturerofthis
appliance, reserves the right to alter its products, their
specicationsand/orpricewithoutnotice.
Harman
®
 is a registered trademark of Hearth & Home
Technologies.
Note: Somegeneratororbatteryback-upsystemsmay
not be compatible withthe micro-processor electronics
on this appliance. Please consult the power supply
manufacturer for compatible systems.

Harman P42i-TC Specifications

General

Brand	Harman
Model	P42i-TC
Category	Indoor Fireplace
Language	English