HEIDENHAIN POSITIP 880 User Manual

110 I Operating Instructions
I – 9 POSITIP 880 Turning Functions
CHANGING PROGRAM BLOCKS. (SEE FIG. I.85)
OPERATING MODE: PROGRAMMING
From within BLOCK FUNCTIONS, press the CHANGE
BLOCKS soft key.
Select the range of blocks you want to change (FIRST
and LAST). Press ENT after each selection.
Enter the tool offset, either OUTSIDE or INSIDE. Press
USE.
Fig. I.85 Changing a block form

HEIDENHAIN POSITIP 880 Specifications

General

Brand	HEIDENHAIN
Model	POSITIP 880
Category	Control Systems
Language	English