Continuous run .Set parameter t/min and t/sec to zero.
需要持续运行（
）时，把 t/min 及 t/sec 的参数值设定为 0。
RPM Revolutions per minute. A numerical value from 500 RPM up to the maximum speed of
the rotor can be set. Maximum speed of the rotor, see Chapter "Anhang/Appendix,
Rotoren und Zubehör/Rotors and accessories". Settable in increments of 10.
每分钟转速。可以把每分钟转数设定为 500 到最大转子速度。关于转子的最大速度，
见“附录， 转子与配件”。可以按照步进为 10 来设定每分钟转速。
RAD/mm Centrifugation radius. Input in mm. For centrifugation radius see Chapter
"Anhang/Appendix, Rotoren und Zubehör/Rotors and accessories". The input of the
radius is only possible if the RCF display（>RCF<）is selected .
离心半径，输入单位为 mm。关于离心半径，见“附录， 转子与配件”。只有选择
了 RCF（>RCF<）显示之后，才能输入离心半径。
RCF Relative Centrifugal Acceleration. A numerical value can be set, which gives a speed
between 500 RPM and the maximum speed of the rotor. Adjustable up to 100 in intervals of 1,
and from 100 in intervals of 10. The RCF value is automatically rounded up or rounded down
with regard to the RPM interval. The input of the RCF is only possible if the RCF display
（>RCF<）is selected. 相对离心加速度。可以设一个数值，对应从 500 RPM 到转子的最
大转速。把这个值从零调到 100，步进为 1。从 100 接着往上调，步进为 10。RCF 值会
自动根据相应的 RPM 进行四舍五入。只有选择了 RCF 显示之后（按键
中的 LED
亮起来了），才能输入 RCF 值。
Starting steps 1 - 9. Step 9 = shortest starting time, Step 1 = longest starting time. 启动步进
1-9。 步进 9＝最短的启动时间，步进 1＝最长的启动时间；
Brake steps 0 - 9. Step 9 = shortest run-down time, Step 1 = long run-down time,
Step 0 = longest run-down time (brakeless run-down). 减速步进 0－9。步进 9＝最短的停转
时间；步进 0＝最长的停转时间（没有减速的停转）；
T/°C Temperature Set Point (only in centrifuges with cooling). Adjustable from -20°C to +40°C, in
1°C intervals. The lowest obtainable temperature depends on the rotor (see Chapter
To Next Page
Loading...
Need help?
General
