User Manual of Network Fisheye Camera
63
Figure 5-41 Motion Detection Settings-Expert Mode
(1) Set the Day&Night switch mode, there are OFF, Auto-Switch and
Scheduled-Switch selectable. If the Day&Night switch mode is enabled, you
can configure the detection rule for the day and night separately.
OFF: Disable the day and night switch.
Auto-Switch: Switch the day and night mode according to the illumination
automatically.
Scheduled-Switch: Switch to the day mode at 6:00 a.m., and switch to the
night mode at 18:00 p.m..
(2) Select Area No. to configure from the drop-down list.
(3) Set the values of sensitivity and proportion of object on area for each area.
Sensitivity: The greater the value is, the easier the alarm will be triggered.
Proportion of Object on Area: When the size proportion of the moving
object exceeds the predefined value, the alarm will be triggered. The less the
value is, the easier the alarm will be triggered.
5. Set the Arming Schedule for Motion Detection.
To Next Page
Loading...
Need help?
General
