HIKVISION DS-2DF8242IX-AELW User Manual

Set Log Server
The log server should support syslog (RFC 3164) over TLS.
Before You Start
●
Install client and CA
cercates before conguraon. Refer to Cercate Management for
detailed
informaon.
●
Select cercates according to the requirement of the log server. If two-way authencaon is
required, select the CA
cercate and the client cercate. If one-way authencaon is
required, select the CA cercate only.
Steps
1.
Check Enable Log Upload Server.
2.
Oponal: Check Enable Encrypted Transmission if you want the log data to be encrypted.
3.
Input Log Server IP and Log Server Port.
4.
Oponal: Select client cercate.
5.
Select CA cercate to the device.
6.
Click Test to test the sengs.
7.
Click Save.
11.12.6 Set QoS
QoS (Quality of Service) can help improve the network delay and network congeson by seng
the priority of data sending.
Note
QoS needs support from network device such as router and switch.
Steps
1.
Go to
Conguraon → Network → Advanced Conguraon → QoS .
2.
Set Video/Audio DSCP, Alarm DSCP and Management DSCP.
Note
Network can idenfy the priority of data transmission. The bigger the DSCP value is, the higher
the priority is. You need to set the same value in router while conguraon.
3.
Click Save.
11.12.7 Set IEEE 802.1X
You can
authencate user permission of the connected device by seng IEEE 802.1X.
Go to
Conguraon → Network → Advanced Sengs → 802.1X , and enable the funcon.
Network Speed Dome User Manual
101

HIKVISION DS-2DF8242IX-AELW Specifications

General

Brand	HIKVISION
Model	DS-2DF8242IX-AELW
Category	Security Camera
Language	English