HIKVISION DS-2DF8242IX-AELW User Manual

4.10 Set Device Posion
Before You Start
Go to Conguraon → PTZ → Basic Sengs → PTZ OSD to enable PT Status display.
Steps
1.
Go to Conguraon → PTZ → Posion Sengs .
2.
Select a PT Mode.
Manual Use a direcon indicang device to determine the North at the device locaon, and
set the North for the device. For details, see Set Manual Compass .
Auto For the device that has built-in e-compass, the compass can automacally tell the
north direcon for the device. For details, see Set Auto Compass .
3.
Click Gyroscope Atude Calibraon to calibrate gyroscope.
Note
Only devices with built-in gyroscope support this funcon.
4.
Set vandal-proof alarm.
Aer enabling the funcon, the device triggers alarms when its posion changes because of
shock or vandalism.
Sensivity
The higher the value is, the easier the alarm will be triggered.
Upload Vandal-proof Alarm
The device uploads the alarm informaon when the alarm is triggered.
Vandal-proof Alarm Voice Warning
The camera triggers the alarm with audible warning.
5.
Select a
Longitude-Latude Mode to set the geographic locaon of the device.
Auto
For device with a built-in posioning module, select Auto to automacally obtain
the longitude and latude of the device locaon.
Manual Get the device locaon informaon in advance, and input the longitude and
latude manually.
6.
Click Save.
What to do next
If you lose direcon when operang the device, you can click Point to North to call the north
posion that is saved in the device.
Network Speed Dome User Manual
32

HIKVISION DS-2DF8242IX-AELW Specifications

General

Brand	HIKVISION
Model	DS-2DF8242IX-AELW
Category	Security Camera
Language	English