Modeling process builds up face model for each face picture. Face model is compulsory for face
picture comparison to take eect.
Modeling Select one or more face pictures, and click Modeling.
Batch Modeling Select a face picture library, and click Batch Modeling.
6.
Oponal: Repeat to create more face libraries.
3.5.2 Set Face Picture Comparison
The funcon compares captured pictures with face pictures in the library and outputs comparison
result. Comparison result can trigger certain acons when arming schedule and linkage method are
set.
Before You Start
You should
rst create a face picture library and add face pictures. See Set Face Picture Library .
Steps
1.
Go to Open Plaorm → Face Comparison and Modeling .
2.
Select Face Picture Comparison.
3.
Check Enable Face Picture Comparison.
4.
Select a face picture library as the reference.
5.
Select desired face
informaon to upload.
6.
Select a face comparison mode.
Best
Comparison
The device captures and compares the target face connuously when the
face target stays in the detecon area, and upload the best scored face
picture and related alarm informaon when the target face leaves the area.
Quick
Comparison
The device capture and compares the target face when the face grading
exceeds the set Face Grading Threshold for Capture.
Face Grading Threshold for Capture
The face grading threshold for the device to judge whether to capture and
upload the face or not.
Max. Capture Interval
The max. interval between two captures when the target is in the
detecon area. The camera takes the capture when it reaches the max.
interval even if the face grading does not reach the set threshold.
Quick Setup Mode
Custom, Face Aendance, and Face Recognion are selectable. Select
according to actual using scenarios. In custom mode, you can set
Comparison Timeout and Comparison Times.
7.
Set arming schedule. See Set Arming Schedule .
8.
Set linkage method. See
Linkage Method Sengs .
Network Speed Dome User Manual
18
To Next Page
Loading...
Need help?
General
