Network Video Recorder User Manual
87
Auto-switch will terminate once the alarm stops and you will be taken back to the Live View
interface.
Note
You must select during Trigger Channel settings the channel(s) you want to make full screen
monitoring.
Audible Warning
Trigger an audible beep when an alarm is detected.
Notify Surveillance Center
Sends an exception or alarm signal to remote alarm host when an event occurs. The alarm
host refers to the PC installed with Remote Client.
Note
The alarm signal will be transmitted automatically at detection mode when remote alarm
host is configured.
Send Email
Send an email with alarm information to a user or users when an alarm is detected. Refer to
Configure Email for details.
Send SMS (Short Message Service)
Send a text message to a cellphone user when an alarm is detected. Refer to for details.
Trigger Alarm Output
Trigger an alarm output when an alarm is triggered. Refer to Trigger Alarm Output for
details.
5. Click OK.
7.8.1 Trigger Alarm Output
Trigger an alarm output when an alarm is triggered.
Steps
1. Go to Menu → Configuration → Alarm → Alarm Output.
2. Select an alarm output and set alarm name and dwell time. Click Schedule to set the arming
schedule of alarm output.
Note
If Dwell Time is set as Manually Clear, you can clear it only by going to Menu → Manual →
Alarm.
To Next Page
Loading...
Need help?
General
