Network Video Recorder User Manual
85
2. Select a thermal camera.
3. Optional: Check Save VCA Picture to save the captured pictures of detection.
4. Select an event detection (Temperature Measurement Alarm, etc.).
5. Set the arming schedule. Refer to Configure Arming Schedule.
6. Set the linkage actions. Refer to Configure Linkage Actions.
7. Click Apply.
6.2.23 Queue Management
After connecting with queue management camera, you can set the arming schedule and linkage
action of queue management.
Before You Start
Ensure the recorder have connected with queue management camera.
Steps
1. Go to Smart Analysis → Smart Event Settings → Other Events.
2. Select a queue management camera.
3. Optional: Check Save VCA Picture to save the captured pictures of detection.
4. Set the arming schedule. Refer to Chapter Configure Arming Schedule for details.
5. Set the linkage actions. Refer to Chapter Configure Linkage Actions for details.
6. Click Apply.
6.3 Target Detection
In live view mode, the target detection function can achieve smart detection, facial detection,
vehicle detection, and human body detection during the last 5 seconds and the following 10
seconds.
Steps
1. In live view mode, click Target to enter the target detection interface.
2. Select different detection types: smart detection ( ), vehicle detection ( ), facial detection
( ), and human body detection ( ).
Note
1. To enable the detection of throwing objects from building, ensure smart detection has
been checked. When the target is identified, the detected view will be displayed on the
left. Meanwhile, the box will display the detected object. (If there is a suspicious target, the
parabola will turn green. If there is a real target and the alarm is triggered, the parabola
will turn red. )
2. For thermal cameras, the temperature measurement event is in smart detection ( ), the
face capture and facial temperature measurement are in facial detection ( ).
To Next Page
Loading...
Need help?
General
